Installation,Debugging and Operation for Tripper Conveyors

Installation,Debugging and Operation for Tripper Conveyors

Belt conveyor tripper is a mobile device which can unload materials freely. Here PK Machinery will introduce you something about its installation, debugging and operation.

Tripper conveyor is a mobile device which can unload materials at the arbitrary point of horizontal section of the belt conveyor, it’s a single part of the belt conveyor. The installation, debugging and operation notes are as follows:

Installation

The installation and primary debugging of tripper conveyor are finished before leaving factory, the only thing needs to place the tripper conveyor on the guide rail, and the conveyor belt should be through the pulley, roller group of tripper conveyor and make sure the conveyor belt goes by the driving pulley of head section, the turnabout pulley of tail section of belt conveyor.

Debugging and operation

Upon the completion of the conveyor belt connection, tripper conveyor cable arrangement, you can debug according to the following steps:

Please check whether the reducer is lubricant, whether there are obstacles that the tripper conveyor may collide when it walks around before start-up .

Inching run the tripper conveyor the first time in order to see if the brake of tripper conveyor is adjusted well, it can not only avoid it collides with the potential barriers, but also can check the facilitating conditions of the guide rail and the walking wheel of tripper conveyor, as well as the operation situation of every part of tripper conveyor.

After confirming all above mentioned operations are normal, the tripper conveyor can be operated on the guide rail at any point, the purpose of the test is mainly observing the walking flexibility, reliability, walking wheel and the guide rail, please adjust it if necessary.

After the above mentioned is qualified, the tripper conveyor can be put into use.